Light fixture installation in North York usually starts with a 1950s or 1960s ceiling. Willowdale, Bathurst Manor and Don Mills are full of bungalows and backsplits where the original box is shallow and the ceiling is stippled, and both of those change how a new fixture sits.
I swap chandeliers, flush mounts, vanity bars, ceiling fans, dimmers and smart switches on the wiring you already have. I bring my own ladders, drop sheets and patching kit, and I clean up before I leave.
Post-war North York bungalows tend to have a shallow pancake box screwed to the underside of a joist, which is fine for a flush mount and wrong for a fan. The stipple finish is the other catch: a smaller canopy leaves a ring of bare texture, so I match sizes or feather the ceiling back before painting. Newer Yonge and Sheppard towers flip it around, with concrete slabs above and fixtures that have to live exactly where the builder put the box.
Mon – Sat: 8:00 AM – 8:00 PM
Sunday: By appointment
Before anything comes down I confirm the power is off at the breaker and dead at the terminals, then look at the box itself: how it is fastened, whether a ground is present, and what weight it was built to carry.
If a fan or a heavy chandelier is going up, a fan-rated box or a brace bar between the joists goes in first, fed through the existing hole so your ceiling stays intact and no patching is needed afterwards.
Conductors are stripped clean and joined with correctly sized connectors, the ground lead is fixed to the ground screw in the box, and the wiring is folded back so nothing is pinched when the canopy is drawn up tight.
Power back on, the fixture is run through every setting, dimmers get their low-end trim set with your bulbs in place, a fan is tested at all speeds and balanced if it moves, and the packaging leaves with me.
Height and access drive most of the cost here. A vanity light at chest height is straightforward work. A chandelier over an open stairwell needs staging, careful handling and more time on site. Adding a fan-rated box or a brace bar to a ceiling that never had one takes longer than hanging a fixture where the support is already correct. Quantity helps, since fixtures done in the same visit share a single setup. Fixtures and dimmers can be supplied by you or by me with receipts, and the price is agreed first.
Nothing starts before the price is agreed. Send a photo or two with your request and I can usually quote without a site visit.
Most times yes. The catch in those bedrooms is the original box, which is usually a thin pancake type meant to hold a few pounds of glass. I take it out and fit a fan-rated box or a brace tied to the joists, then hang the fan from that. If the ceiling is low, I will steer you toward a hugger model so nobody ducks.
Tell me what needs fixing and get a free, no-obligation quote — I usually reply within one business day.