Door repair in Brampton is usually a list rather than a single door. Homes in Springdale, Mount Pleasant and Fletcher's Meadow have a lot of doors, and builder-grade hinges tend to loosen on all of them at about the same time.
I am Sercan and I work alone, so I would rather come once and deal with the whole list. Doors that rub, doors that swing open on their own, latches that miss, closets that will not shut. I look at everything, give you one free quote, and stick to it.
Brampton houses in Springdale, Mount Pleasant and Fletcher's Meadow are large, and a hollow-core builder door on every bedroom means the calls here are lists rather than single doors: eight or nine that rub, rattle or will not latch. Hinge screws in those homes strip out of thin jamb stock, so I go through into the stud behind instead. Older Bramalea houses from the sixties are a different job again, with narrower openings and doors of solid wood that reward planing.
Mon – Sat: 8:00 AM – 8:00 PM
Sunday: By appointment
I look at the gap around the door before touching anything. Where it is tight, where it is wide, and how the latch meets the strike tells me whether the trouble is the hinges, the jamb, the floor or the door itself.
Most doors come right by resetting hinge screws into framing, plugging stripped holes, shimming a hinge leaf or re-cutting the strike plate. Planing stays a last resort, and any bare edge gets sealed once the fit is correct.
Where a door or jamb is past saving, the hinge jamb is set plumb and shimmed behind every hinge, the reveal is checked from top to bottom, and hardware is bored and mortised to fit rather than forced into place.
The door is swung through its full arc, left at several positions to confirm it stays put, then latched and unlatched repeatedly with the strike adjusted until it catches cleanly without needing a shove.
Adjusting a door that drags is usually short work, and several doors in the same visit share one setup. Cost rises with an opening that is out of plumb, a sagging or split jamb, hardware that has been repaired badly before, or an exterior door where the threshold and weather stripping also need attention. Fitting a slab into an existing jamb takes longer than hanging a pre-hung unit, because the hinges have to be mortised and the hardware bored. Doors and hardware can be supplied either way, and the price is agreed before work starts.
Nothing starts before the price is agreed. Send a photo or two with your request and I can usually quote without a site visit.
Usually yes, and that is how I prefer to work. Most of what goes wrong on builder doors in Brampton homes comes down to the same handful of faults, so once I am set up the second door takes far less time than the first. I walk the house with you first, note what each door needs, and give you one quote covering the lot.
Tell me what needs fixing and get a free, no-obligation quote — I usually reply within one business day.